Here i used “Kill” Command to kill the supplicants, you can follow any of these methods Step 4: There are two options from here on, you can either kill the supplicants or move on with the other command.ġ) By Using Kill Command and Stopping the Wlan0 SupplicantsĢ) By Using the Command “ airodump-ng mon0” instead of kill and the next ![]() Step 3: Now you can see the available supplicants and the interfaces Step 2: Here I will be selecting wlan0 as my interfaceĪnd the Next Command Is “airmon-ng start wlan0” ![]() Step 1: Open Terminal and type “ifconfig” (Optional) How To Hack Wifi WPA/WPA2 – WPS Enabled Netork without Using Wordlist WPS Means Wifi Protected System, This Is a Different Type of security system which is enabled for some routers, it is the best method to hack wifi, But it does have Limitations, they are some routers with WPS enabled are secured by another security called “AP RATE LIMITING” if you see this just leave that network and go to another network.ġ) Till now no one found any method to break that security system, may be in my later posts I will try to post how to break that security systemĢ) Wpa And Wpa2 Networks can only be hacked using wordlist, Which uses Brute Force Attack in which probability of getting password is only 35%ģ) But In Reaver Method Probability is 100% (Only If AP Rate Limiting Is Not Available)Ĥ) So it is better to go for reaver method if wps is availableĥ) It consumes less time than Brute Force Attack Or Dictionary AttackĦ) If the network that you want to hack has an excellent signal and if your system is in good condition, then the hack completes in 5 – 18 Hours.
0 Comments
Leave a Reply. |